We use cookies - Find out more
Telephone: 01502 716993
Part Identifier ?
R&D Marine Logo

R&D Compression Flexible Engine Mount (100-180LBS / 5/8" Stud)

Part No. 207003

£38.23 You pay £38.23 Incl VAT You pay £31.86 Excl VAT

RRP £41.33 £34.44

Save £3.10 (7.5%) Save £2.58 (7.5%)


Add to Wishlist
Brand R&D Marine
Country of Origin United Kingdom
Engine Mount Compression Engine Mounts
Maximum Load 45kg to 82kg (100lbs to 180lbs)
Mount Pre-loaded 1.5mm (0.06")
Deflection 2.3mm (0.09")
Stud Size 5/8" UNF
Length 130mm (5.13")
Width 76mm (3")
Height 116mm (4.58"), Base: 44.5mm (1.75")
Hole Centres 101.6mm (4")
Dimensions Height Adjusting Nut Thickness: 14mm (0.55")
Suitability 2 & 3 Cylinder Long Stroke Engines, 4 Cylinder Engines, 6 Cylinder & Over Engines

The compression flexible engine mounting is a low height mount with minimum deflection.

Typical uses: 2 and 3 Cylinder Long Stroke, 4 Cylinder, 6 Cylinder and more.

Compression mountings are lower in height and give reduced isolation compared to Shear and Super mountings. Clearance between the underside of the height adjusting nut and the top washer of the mounting should not be more than 9mm (0.375").

If required, increase the height with a spacer under the mount. The first adjusting nut adds approximately 10mm.

The dimensions of the flexible engine mount are shown in the drawing located below the main image, click the image to and hold your mouse over the image view the full size drawing.

You may also need

This product has been added to your basket.