We use cookies - Find out more
Telephone: +441502 716993
? Part Identifier

Rule LoPro LP900S Automatic Submersible Bilge Pump (12V / 56lpm / 19mm, 25mm or 28mm Hose)

Part No. 504166

44.36 You pay £53.23 Incl VAT You pay £44.36 Excl VAT

RRP £59.15 £49.29

Save £5.92 (10.0%) Save £4.93 (10.0%)

IN STOCK

1 reviews
Add to Wishlist
Overview
Brand Rule
Series LoPro
Model LP900S
Automatic Bilge Pumps Yes
Voltage 12V DC
Fuse 7.5A
Amps 4A
Flow Rate at Zero Head 56 litres/minute (12.5 gallons/minute)
Maximum Recommended Head
Outlet For 19mm (3/4"), 25mm (1") or 28mm (1 1/8") ID Hose
Length 237mm (9.3")
Width 56mm (2.3") Minimum
Height 56mm (2.3"), Switch cut in height: 38mm (1.5")
Ignition Protected Yes
Warranty (Years) 3
Notes The entire pump body swivels up to 180°, making the pump extremely easy to install
Description

The LoPro brings Rule pumping power to tight spaces. The LP900S submersible bilge pump features a fully rotating discharge body for installation flexibility, allowing horizontal or vertical mounting. The Rule LoPro pump is supplied with a choice of different sized discharge ports for 19mm (3/4"), 25mm (1") or 28mm (1-1/8") bore hose. This bilge pump also features the following 3 operation modes:
High water mode: The pump starts when the water level reaches 50mm (2")
Low water mode: Turn the motor cartridge 180° and the sensor is at 33mm (1.3")
Full Electronic mode: The pump automatically turns on every 2.5 minutes to check for water, if water is detected the pump runs until the water is gone.

Rule LoPro pumps also feature a non-return valve in the straight outlets to stop any water running back down into the pump, although this is not in the elbows to avoid a reduction in flow rate. The non-return valve will prevent any water running back down the pipes into the pump, which would then require pumping out again.

The LP900S features a backup device that will detect if the bilge switch has become covered by oil, grease or debris, via checking the water resistance against the impeller. If no water is present, the pump will revert back to the auto timed mode until the sensor has been cleaned.

The LoPro bilge pump should only be used in the bilges of leisure craft, if used as a sole or primary bilge pump it is only suitable for vessels up to 24 metres (78.8ft).


You may also need

Customer ReviewsAdd a review

06/11/2016
Rule LoPro LP900S auto bilge pump
"Just received and fitted this auto bilge pump from ASAP. Its well made and comes with straight and 90 degree hose connectors for 19, 25 and 28 mm diameter hoses.
Many bilges on boats are very narrow and this pump fits the bill perfectly. The pump can be set to operate at 2 levels of water and also can be set to sense for the presence of water automatically. Order this with some super flexible Seaflow bilge pump hose and you will have a reliable auto pump out bilge water system.The rule pro is also available in the basic non auto version at a good cost saving. The warranty on the pump is 3 years and Rule have been making good quality pumps for many years and are one of the market leaders. Dave R......"

Dave
See more reviews
loading
This product has been added to your basket.
Loading   Loading...